直播夜月官方版-直播夜月免费版app下载-直播夜月永久免费版下载

XW1100A sensing cable has the advantage of low cost and high reliability. It is used with XW-DC seris controller in pair though it also applies universally to most  alarm hosts. It is used in the regional leakage detection (leakage detection system based on short circuit theory). It can detect the presence of water along its length. Installed with a alarm module, the cable senses water intrusion, triggers an alarm.

Distributed sensing

XW1100A sensing cables provide distributed leak detection over a wide range of areas. The cable is available in a variety of lengths to provide as much coverage as needed.

Design flexibility

XW1100A sensing cable is designed for a range of applications, including data center subfloors, telecommunication rooms, HVAC equipment locations, pipes, electrical vaults, storage areas, tanks, and roofs. The cable is small, lightweight, and flexible, allowing easy installation.

Advanced technology

XW1100A is constructed of 2 light but high density polyethylene sensing wires sensing wires, an alarm signal wire, and a continuity wire which are pressed parallel together. The 2 detection wires in parallel structure make the cable smaller and less false alarm caused by electrostatic. This structure reduces the cable diameter and material cost. The rugged cable construction exposes no metal, and enables the cable to be reused even in corrosive environments. XW1100A sensing cable is mechanically strong and resistant to corrosion and abrasion. 

Ordering Information

XW1100A modular sensing cable with factory-installed connectors

It can be customized to different length according to the actual situation.

Notes:

Cable Characteristics

Cable diameter                             width 7.0 mm X thickness 2.0 mm

External resistance                          20 ohm /100 meters

Carrier                                     light but high density polyethylene

Cable weight                               0.012 kg/meter

Cable color                                Yellow

Maximum exposure temperature               80°C

Installation

Each XW1100A sensing cable requires an outgoing line to connect with the alarm host. (The sensing cable with plug needs customer additionally purchasing the outgoing line and the terminator and the standard length of the outgoing line is 3 meters. The sensing cable without plug is defaulted connecting to a 2 meters long outgoing line by the factory with no additional cost.) Special installation adhesive is required to fix the cable on the flat surface to make the accurate alarm. Accessories (terminator, line jumper, etc) can connect multiple sensing cables together to form a complete detection loop.

Installation instructions 

?induction line in the laying process to avoid contact with metal objects.。

?Induction line in the process of laying keep dry and clean.

?Induction line in the docking process, please pay attention to male female connector pins order, alignment hole location and gently insert lock screw clockwise loops (counterclockwise).

?Sensor cable laying area should be avoided by electrostatic interference.

?Induction line in laying area are not allowed to overlap or contact.